The Hardware Information Does Not: Match With Your Dongle Autodata

You may need to run the (often found in the installation folder) to generate a new Site Code and request a refreshed activation from your provider. 4. Address Software Conflicts (Emulators)

This error often triggers after a hardware change (like upgrading your RAM or Hard Drive). Autodata’s security system "locks" itself to your specific hardware configuration.

Remove the dongle, wait 10 seconds, and try a different USB port (preferably one directly on the motherboard rather than a USB hub). You may need to run the (often found

If there is a yellow exclamation mark, right-click and select .

Lack of permissions can prevent the software from "reading" the USB port correctly. Right-click the Autodata shortcut. Select > Compatibility . Check the box "Run this program as an administrator." Apply and try launching again. Autodata’s security system "locks" itself to your specific

Download the latest from the official Thales/Gemalto website and install it. Restart your PC afterward. 3. Match the "Site Code" and "Activation Code"

The most frequent cause is an outdated or corrupted driver. Autodata usually relies on drivers. Go to the Device Manager on your PC. Lack of permissions can prevent the software from

Sometimes registry "optimizing" tools delete the registration entries that link the software to the hardware ID. 5. Run as Administrator

Here is a straightforward guide to troubleshooting and fixing the issue. 1. Check the Physical Connection

Before diving into software settings, rule out a hardware failure: