Simrad Rf300 Installation Manual Better Access

Ensure the distance from the rudder post center to the ball joint (Y1) is equal to the distance from the RF300 center to its transmitter rod connection (Y2).

Install the RF300 on a stable platform near the rudder post. The center of the RF300 should ideally be in line with the center of the rudder post to ensure geometric accuracy. simrad rf300 installation manual

Slowly turn the helm from lock to lock by hand. Verify that the rod does not bind and that there is no mechanical interference throughout the full range of motion. 2. Wiring and Connection The RF300 uses a unique two-wire frequency-based signal . Ensure the distance from the rudder post center

The is a high-resolution rotary rudder feedback unit designed to provide precise rudder position data for Simrad autopilot systems, specifically for vessels with inboard engines. Installing this unit correctly is vital for smooth, accurate auto-steering and to avoid common errors like rudder feedback alarms. Key Specifications Interface 2-wire frequency interface Voltage 12-16V via CAN (typical 12V) Cable Length 10 meters (33 feet) Dimensions 99 x 65 x 177 mm Waterproof Rating 1. Physical Installation & Mechanical Linkage Slowly turn the helm from lock to lock by hand

Drill and tap the rudder tiller arm (typically using a 4.2 mm drill and 5 mm tap).

While it is a two-wire system, always follow the specific wiring diagram in your autopilot computer manual to ensure the frequency signal is correctly interpreted.