Makerbase Mks Dlc V21 Manual Link Exclusive -

Before powering on your board, ensure all connections are secure to avoid shorting the components. 1. Power Connection

Ensure the "Enable" pin on the driver matches the "EN" pin on the board.

Insert your stepper drivers into the slots for the X, Y, and Z axes. makerbase mks dlc v21 manual link

Connect your DC power supply to the screw terminals. Double-check the polarity (+ and -) marked on the board. Most setups use 12V for lasers and 24V for CNC motors to get better torque. 2. Stepper Drivers

The DLC v2.1 is an "all-in-one" board designed to run GRBL. It supports 3-axis control (X, Y, and Z) and features specific ports for laser TTL control and CNC spindles. Key Specifications ATMega328P (8-bit) Input Voltage: 12V to 24V DC Supported Drivers: A4988, DRV8825, TMC2208, TMC2209 Interface: USB for PC connection 🔌 Setup and Wiring Guide Before powering on your board, ensure all connections

Use the Spindle relay or PWM output to control your motor tool. 💻 Software Configuration

Since the MKS DLC v2.1 runs GRBL, it is compatible with a wide range of open-source software. Recommended Software The best free option for laser engraving. Insert your stepper drivers into the slots for

Check if your $32 setting is correct and ensure the TTL wire is on the correct pin. If you need more specific help, I can guide you through: The exact jumper settings for your specific stepper drivers A step-by-step guide for configuring LaserGRBL How to wire limit switches to prevent crashes

Found in the hardware folder of the repository. Latest Firmware (GRBL): Available in the firmware section. 🛠️ Hardware Overview

Excellent for CNC milling and routing. Candle: A clean, simple interface for GRBL-based CNCs. Common GRBL Settings