With the camera online (solid green LED), you must link it to your security account: 1080p Indoor Wi-Fi Camera Installation Guide - Surety
: A 2.4 GHz Wi-Fi connection. Note that the does not support 5 GHz networks.
Using a smartphone or computer, search for available Wi-Fi networks. Connect to the network named , where "XX" represents the last six characters of the camera's MAC address. 3. Access the Configuration Portal http v515 install
Before starting the installation process, ensure you have the following ready: : Your camera and its included AC power adapter.
: Perform the setup near the camera's final location to ensure a strong Wi-Fi signal. Step-by-Step Installation Guide via http://v515install 1. Power On the Camera With the camera online (solid green LED), you
: An active Alarm.com account with a service package that supports video.
Follow the on-screen instructions in the portal to scan for and select your home's 2.4 GHz Wi-Fi network. Enter your network password when prompted. The camera's LED will turn once it has successfully connected to the internet. 5. Add the Camera to Your Alarm.com Account Connect to the network named , where "XX"
Troubleshooting : If the LED is not blinking white after two minutes, hold the for about 6 seconds until it begins to blink. 2. Connect to the Camera's Temporary Wi-Fi
. This address allows users to connect their camera to a local 2.4 GHz Wi-Fi network when using Access Point (AP) mode. Pre-Installation Checklist
Open a web browser on the same device and enter http://v515install or http://v515install.com into the URL field. This will launch the camera's internal setup page. 4. Join Your Home Wi-Fi