8 channels in total, including 7 mic/line inputs with XLR and 1/4" connectors.
24-bit processor featuring 100 presets (reverb, delay, chorus, flanger, etc.).
Ensure all cables are fully seated. For passive speakers, check the mode switch (Stereo/Bridge) on the back to ensure it matches your cabling setup.
Use the separate FX level controls for the main and monitor mixes to balance the wet/dry signal.
Connect microphones via XLR cables and instruments (like keyboards or guitars) via 1/4" line inputs. For playback from external devices like phones or CD players, use the dedicated . 2. Using Built-in FX
Dual 400W amplifiers (800W total). It can operate in Stereo , Main/Monitor , or Bridge Mono (800W @ 8 ohms) modes.
If you experience feedback, check the bi-color Signal/Peak LEDs on each channel. If they are constantly red, lower the channel gain and use the 7-band graphic EQ to notch out problem frequencies.
Getting started with the PA2400 involves proper signal routing and power management to avoid equipment damage.
Each channel has a 3-band EQ, while the master section features dual 7-band graphic equalizers (one for mains and one for monitors).