Gea+gforce+panel+manual+install ^new^ May 2026

The GEA G-Force panel (also referred to as the ) is a legacy microprocessor control system designed primarily for screw compressor and refrigeration system management. While it has largely been succeeded by the GEA Omni panel , many G-Force units remain in active service or are installed as retrofits.

This board acts as the bridge between the processor and field devices via a robust RS485/Modbus network. gea+gforce+panel+manual+install

Use two-conductor shielded twisted pair cables for all sensor signals. Shielding prevents electrical noise from high-voltage components from interfering with sensitive analog inputs. The GEA G-Force panel (also referred to as

Standard units typically require 120Vac, 60Hz, 1Ph, 25A . Use two-conductor shielded twisted pair cables for all

Set the (0%) on the panel once the raw signal milliamps stop moving.

The following guide covers the manual installation procedures, wiring requirements, and initial setup for a G-Force control system. 1. Pre-Installation Requirements

The 15" LCD can be operated with a stylus or gloved finger.