Aboled Sc-ds-d 2014-i Kontroller May 2026

If using an RF remote, hold the pairing button on the receiver for 3–5 seconds until the lights blink, then press any button on the remote to link them. Common Applications

Connect the positive (+) and negative (-) wires from your power supply (PSU) to the corresponding DC input terminals on the controller.

After powering on, you must set the pixel length. Press the function button ( * ), enter the number of pixels (e.g., 100), and press the function button again to confirm. Aboled sc-ds-d 2014-i kontroller

Users can fine-tune lighting with 256 levels of dimming and RGB color adjustment in 10% increments for rapid changes, or hold buttons for continuous smooth transitions.

Insert the strip’s data wire into the terminal marked 'D' or 'DAT'. If your strip has a clock line, connect it to the 'CLK' terminal. If using an RF remote, hold the pairing

This controller is specifically engineered for "smart" or addressable LEDs, allowing for individual pixel control rather than just changing the color of an entire strip at once.

It supports a wide range of popular IC types, including WS2811, WS2812B, UCS1903, and TM1804. Press the function button ( * ), enter

Are you planning to use this controller for a or a multi-strip matrix setup?

The device can manage up to 1,024 pixels , making it suitable for long runs of LED tape or intricate matrix displays.